Important notes
- Power supply must be:
100 - 240 VAC and requires NEUTRAL Wire (NUL);
OR
24 - 30 VDC
- A Z-Wave Hub is required!
- Designed to be installed in standard wall switch boxes or anywhere else it is necessary to control electric devices. Allows us to control the connected devices either via Z-Wave or via mechanical switch.
- It can control 2 circuits with loads that doesn't exceed a total power of 2280 W (VAC) or 228 W (VDC).
- Do not connect loads greater than those recommended!
- Do not connect types of load other than resistive or incandescent!
How it works
Smart Module is a small size module created by Fibaro, that can be integrated in standard wall switch boxes. It allows us to remotely control connected devices using the Z-Wave Network (a Z-Wave Hub is required).
Notes for the diagrams:
S1 - terminal for 1st switch;
S2 - terminal for 2nd switch;
L - terminal for Live wire (100 - 240 VAC) or - (for VDC);
IN - terminal for Live wire (100 - 240 VAC) or - (for VDC);
Q1 - output for 1st circuit;
Q2 - output for 2nd circuit;
N - terminal for Neutral wire (for AC) or + (for VDC);
B - service button (used to add/remove the device from the Z-Wave network).

Where it works
It can be fit into standard wall switch boxes or anywhere else it is necessary to control electric devices.

Tech Specs
Power supply
|
110 - 240 VAC. ~ 50/60Hz
24 - 30 VDC
|
Current
|
Maximum 6 A on each channel (Q) - resistive or incandescent loads
Maximum 9.5 A total when both channels (Q) are used
|
Overcurrent protection
|
External 6 A circuit breaker required - if there is only 1 channel (Q) used
External 10 A circuit breaker required - if there are both channels (Q) used
|
Active element
|
micro-gap relay switch μ |
Operating temperature
|
0 - 35 °C |
Technology
|
868.42 MHz Z-Wave Plus (500 series) |
Dimensions (L x W x H) [mm]
|
42.5 x 38.25 x 20.3 |
Range |
- up to 50 m outdoors
- up to 30 m indoors
depending on terrain and building materials
|
Security
|
AES - 128 Encryption
|