With the WiDom Dimmer you get the possibility to integrate existing switchable and dimmable electric installations such as lighting or ceiling fans into your Z-Wave network. Thus, the connected load can be switched and dimmed via Z-Wave or with your existing toggle or momentary switch. Make your lamps smart with the WiDom Dimmer. The following types of lamps can be controlled by the WiDom Dimmer:Traditional incandescent and halogen bulbsDimmable energy-saving CLF fluorescent bulbsDimmable LED bulbsDimmable Low voltage bulbs with transformerThe compact radio module is placed in a wall box right behind the normal switch. The switch is no longer directly connected to the load but acts as an input device for the WiDom Dimmer that is controlling the load. The switch only sends control signal to the insert which controls the load. With your gateway you also can define different times when the lamps shall turn ON or OFF. With the LED you get feedback directly if the electrical connections are correct. Thus the installation is much more easy. Furthermore the WiDom Dimmer acts as a repeater and increases the reliability of your Z-Wave network. Equipped with a very precise power metering funcionality as well as overheat protection mode it is ahead of competing products.Features:Flush-mounted trailing edge Z-Wave DimmerIntegrates existing installations (lighting, ceiling fans) into the Z-Wave networkSuitable for different lamp types (halogen, LED, CLF fluorescent, etc.)Works with every type of switchEven with small loads, there will be no flickeringPower metering functionOverheat protection (turn off the load when the temperature exceeds a certain level)Power supply: 110 - 230V, 50/60HzPower consumption: < 1WMaximum load: 300WWireless technology: Z-Wave PlusDimensions: 37x37x17mm