- Out of stock

Heatit Z-Dim is a Z-Wave dimmer for many different types of light sources. It will only work with a neutral wire (L + N) for loads that require a maximum power of up to 200 [W].
Works with:
- LED Bulbs 1 - 200 VA;
- Halogen and incandescent bulbs (230 VAC power supplied);
- Dimmable LED - drivers & electronic transformers.
Doesn't work with:
- Inductive loads;
- Fluorescent lighting;
- Fans;
- Linear transformers.
The Heatit Z-Dim works on low loads without causing the lights to flicker.
Our engineers will offer you the best solutions for your projects
Refunds are processed within 1-2 days
Using latest standards in security policies
- Power supply must be 100 - 240 VAC and does require NEUTRAL Wire (NUL);
- A Z-Wave Hub is required!
- Designed to be installed in standard wall switch boxes or anywhere else it is necessary to control electric devices. Allows us to control the connected devices either via Z-Wave or via a switch.
- It can control one circuit with loads that don't exceed 200 W.
- Use max. 2.5 mm² wires (according to load).
- Do not connect loads greater than those recommended!
- Do not connect other types of loads than those recommended!
- Do not connect the power supply without a load!
Heatit Z-Dim is a Z-Wave rotary dimmer for many different types of light sources. It allows us to remotely control connected devices using the Z-Wave Network (a Z-Wave Hub is required).
The dimmer is equipped with a multiway switching option. This allows you to control and dim a light source from one dimmer, and later turn it off with another one.
Notes for diagram:
L - terminal for Live wire (100 - 240 VAC);
N - terminal for Neutral wire;
~ - output terminal of the Dimmer (controlling the connected light source);
S - terminal for switch;
It can be fit into standard wall switch boxes or System 55 frames to control electric devices:
- LED Bulbs 1 - 200 VA;
- Halogen and incandescent bulbs (230 VAC power supplied);
- Dimmable LED - drivers & electronic transformers.
The dimmer is equipped with a multiway switching option very practical for stairwells, long hallways, etc.
Starts at 1VA and dims up to 200VA LED |
|
Trailing edge |
Multiway switching option |
Electronic thermal cutoff with automatic reset |
|
Firmware updates (OTA) |
Power metering |
|
Z-Wave 500 Chip |
Supports encryption mode: S0, S2 Authenticated Class, S2 Unauthenticated Class |
Power supply |
|
230 VAC, 50 Hz |
Chip |
Z-Wave 500 |
|
Load |
1 VA - 200 VA |
|
Input current |
0.9 A |
|
Ambient temperature |
0 - 40 °C |
|
IP code |
IP 20 |
|
Dimensions (L x W x H) |
84 x 84 x 43 mm |
You might also like